MXR Iso-Brick Power Supply

http://www.jimdunlop.com/product/iso-...

The MXR Iso-Brick Power Supply is small and light with tons of quiet, noise-free DC power on tap ready to run a wide range of pedal types without crowding or weighing down your pedalboard.

Each of the Iso-Brick Power Supply’s 10 outputs is fully isolated, eliminating gig-ending ground loop noise. Whether analog or digital, positive or negative ground, this power box has you covered. The MXR team broke down these 10 outputs to accommodate a variety of voltage and current requirements: two 9V outputs at 100mA, two 9V outputs at 300mA, two 9V outputs at 450mA, two 18V outputs at 250mA, and two variable outputs adjustable from 6V to 15V at 250mA. The two variable outputs can be used to emulate voltage “sag,” a drained battery effect sought by many vintage tonechasers.

On top of all that, the Iso-Brick Power Supply comes in a small, lightweight housing that’s built like a tank. Features power on/off and connection status LEDs. Put this little box on your pedalboard to make sure it runs reliably and quietly gig after gig.

SIGNAL CHAIN INFO FOR DEMO:
This exact pedal board was used for the soundtrack
Iso-Brick + Cry Baby Mini + Fuzz Face Mini + MXR Super Badass Distortion + MXR Phase 90 + MXR Analog Chorus + MXR Carbon Copy Delay + MXR 10 Band EQ

VIDEO CREDITS:
Executive Producer: Jimmy Dunlop
Director: Joey Tosi
Art Director: Graham Shaw
Editor/Music Supervisor: Max Baloian
Set Dresser: Mick Waller
Director of Photography: Donavan Sell
Guitar Performance: Eli Nelson
Score: Eli Nelson & Max Baloian
Recorded and Mixed: Nino Moschella, Bird & Egg Studios, Richmond CA.

SPECIAL THANKS:
Suhr Guitars & Amps, http://www.suhr.com
Carr Amplifiers, http://carramps.com/
Royer Microphones, http://www.royerlabs.com/
Telefunken Microphones, http://www.telefunken-elektroakustik.com/