Vertex Effects | 5 years ago

Pedalboard interfaces have been crucial in many of the Rig Doctor's pedalboard builds. The truth is, you don't need to be an expert rig builder to make your own interface. In this video, we walk you through the steps of building an interface that allows you to run your time-based effects (Delay, Reverb) in your amp's FX Loop - Four Cable Method (4CM), or Two Cable Method (2CM), with all of your pedals in series in front of one amplifier.

SUBSCRIBE ➜ https://youtube.com/vertexeffectsinc

🔻SUPPORT THE RIG DOC 🔻
https://patreon.com/rigdoctor

⬇️ CLICK BELOW FOR ALL TEMPLATES, DIAGRAMS, & MATERIALS ⬇️
https://vertexeffects.com/diy-interface

⬇️ CLICK BELOW FOR RIG DR APPROVED MATERIALS & ACCESSORIES ⬇️
https://vertexeffects.com/rig-dr-recommended-pedalboard-materials

TABLE OF CONTENTS
Intro - 00:01
Drilling template - 00:46
Cutting out template - 01:51
Taping template to enclosure - 02:33
Punching holes on template - 04:13
Drilling pilot holes - 04:39
Installing 1/4" jacks - 06:09
Choosing your hookup wire - 09:36
Stripping cables - 10:27
Prepping cables - 10:50
Wiring the interface - 12:28
Dremel paint off enclosure holes - 17:15
Labeling interface - 17:45
Interface demonstration - 18:11
Outro - 19:50

#TheRigDoctor #PedalboardInterface #JuctionBox